They are a combination base and cap flashing that are usually installed behind the siding and caps and over the sloped roofing materials.
Roof apron flashings.
Protects fascia board finishes the roof line and guides run off into gutters.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
It is used for roof to wall flashing.
This drip edge flashing provides protection from water damage along the eaves and rake of a roof.
The flashing helps guide run off away from shingles and into the gutters featuring an extended drop provides more protection for the fascia board.
An apron flashing is responsible for diverting water from a vertical surface into a gutter system.
Placed opposite to base flashing or above base flashing counter flashing completes the two part team.
The base flashing or apron flashing is the bottom piece.
Flashings near the edges of roofs or walls can be subjected to suction or negative wind loads that can be greater than other positive imposed loads.
The extra kick at the bottom of the face directs run off away from the structure.
30 degree white aluminum.
White aluminum roof apron flashing.
The flashing helps guide run off away from shingles and into the gutters.
Apron angle flashings are one piece l shaped flashings usually on the lower side of a chimney.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
Step flashing is a rectangular piece of flashing bent 90 degrees in the center.